Filter
Top Products
8
6. Insert the tab on one of the Handrail Brackets
(79) into the indicated slot in the Left Upright
(70). Attach the Handrail Bracket with a 3/4” Tek
Screw (72).
Attach the other Handrail Bracket to the Right
Upright as described above.
See steps 2 and 4. Fully tighten the two
Endcap Screws (108).
70
Slot
6
79
72
5. With the help of a second person, carefully raise
the Left Upright (70) and the Right Upright (not
s
hown) to a vertical position.
A
ttach the Latch Housing (71) to the Left Upright
(70) with two 3/4” Screws (23); start both
Screws and then tighten them. Note: Make
sure that the large hole in the Latch Housing
is on the indicated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Next, insert the pin into the Latch
Housing (71). Then, tighten the knob onto the
pin.
70
Pin
Collar
Spring
Knob
Large
Hole
5
23
71
23
7. Identify the Left Handrail Cover (68), which as a
LEFT sticker on it. Slide the Left Handrail Cover
onto the upper end of one of the Handrails (62).
Slide one of the Handrail Caps (69) onto the
lower end of the Handrail. Make sure that the
small hole in the Handrail Cap is on the bottom.
Slide the Handrail (62) onto the post on the Left
Upright (70) and onto the left Handrail Bracket
(not shown). Finger tighten two 1 1/4” Bolts (63)
into the Handrail and the post;
do not fully
tighten the Bolts yet.
Tighten a 3/4” Screw (23) into the small hole in
the Handrail Cap (69) and into the Handrail
Bracket (not shown).
Attach the other Handrail (62) to the Right
Upright (76) as described above.
70
Post
69
69
68
Small Hole
62
62
74
63
63
76
23
7
23
Small
Hole