Filter
Top Products
H
OW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
cold temperatures, allow it to warm to room tem-
perature before turning on the power. If you do not
do this, the console displays or other electrical
c
omponents may become damaged.
Plug in the power cord (see page 10).
Locate the reset/off
circuit breaker on the
treadmill frame near
the power cord. Make
sure that the circuit
breaker is in the reset
position.
Stand on the foot rails of the treadmill. Find the clip
attached to the key (see the drawing on page 11)
and slide the clip onto the waistband of your
clothes. Next, route the cord attached to the clip
under the handgrip pulse sensor, and insert the
key into the console. After a moment, the displays
and various indicators will light. Important: In an
emergency situation, the key can be pulled
from the console, causing the walking belt to
slow to a stop. Test the clip by carefully taking
a few steps backward; if the key is not pulled
from the console, adjust the position of the
clip.
HOW TO USE THE MANUAL MODE
Insert the key into the console.
See HOW TO TURN ON THE POWER above.
Select the manual mode.
When the key is in-
serted, the manual
mode will be selected
and a track will appear
in the display. If a pro-
gram has been
selected, remove the
key and then reinsert it.
Start
the walking belt.
To start the walking belt, press the Start button,
the Speed increase button, or one of the ten num-
bered speed buttons.
If the Start button or the Speed increase button is
pressed, the walking belt will begin to move at 1
m
ph. As you exercise, change the speed of the
walking belt as desired by pressing the Speed in-
c
rease and decrease buttons. Each time a button
is pressed, the speed setting will change by 0.1
mph; if a button is held down, the speed setting
will change in increments of 0.5 mph. Note: After
the buttons are pressed, it may take a moment for
the walking belt to reach the selected speed setting.
If one of the ten numbered speed buttons is
pressed, the walking belt will gradually increase in
speed until it reaches the selected speed setting.
To stop the walking belt, press the Stop button. To
restart the walking belt, press the Start button, the
Speed increase button, or one of the ten num-
bered buttons.
Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
Incline buttons. Each time a button is pressed, the
incline will change by 0.5%. Note: After the buttons
are pressed, it may take a moment for the treadmill
to reach the selected incline setting.
Monitor your progress with the matrix, the
training zone bar, and the displays.
The matrix—When the
manual mode is se-
lected, the matrix will
display a 1/4-mile track.
As you exercise, the in-
dicators around the track
will light in succession
until the entire track is lit. The track will then
darken and the indicators will again begin to light
in succession.
The training zone bar—
The training zone bar
shows the approximate
intensity level of your ex-
ercise. For example, if
three to six indicators in
the bar are lit, the bar
shows that your pace is
ideal for fat burning.
5
4
3
2
1
3
2
1
Reset
Position
12