Filter
Top Products
ASSEMBLY
T
o hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex keys and your own phillips screwdriver , rubber
mallet , and adjustable wrench .
For help identifying the assembly hardware, see the drawings below.
If a part is not in the parts bag, check
to see if it has been pre-assembled.
To avoid damaging plastic parts, do not use power tools for assembly.
1/2” Screw (119)–1
3/4” Tek Screw (58)–8
1
Nut (13)–2
Wheel Bolt (64)–2
1” Tek Screw (39)–4
Extension Leg
Nut (46)–2
3/4” Screw (2)–6
1/4” Star Washer
(73)–2
Handrail Bolt (37)–4
Extension Leg Bolt/
Handrail Bolt (93)–6
Silver Ground
Screw (75)–1
Console
Bolt (90)–2
3” Bolt (96)–2
Star
Washer (95)–8
63
86
57
69
39
39
93
95
46
1
6
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully
tip
the treadmill onto its left side as shown. Partially
fold the Frame (86) so the treadmill is more sta-
ble.
Do not fully fold the treadmill until it is
completely assembled.
Remove the metal packing insert from the base
of the Uprights (69). Insert an Extension Leg (63)
into the base of the Uprights (69). Hold an
Extension Leg Nut (46) in the bottom of the
Extension Leg, and thread a Extension Leg Bolt
(93) with a Star Washer (95) into the top of the
Extension Leg. Next, thread a 3” Bolt (96) with a
Star Washer into the bottom of the Extension leg.
Firmly tighten the Bolts.
Attach two Base Pads (57) to the base of the
Uprights (69) with two 1” Tek Screws (39).
95
96