Filter
Top Products
7
3. Identify the Left and Right Uprights (106, 107); the Left
Upright has two small holes in the indicated location.
Orient the Uprights so that the brackets are in the posi-
tions shown.
See drawing 3a. Have a second person hold the Right
Upright (107) near the Base (69). Insert the Upright Wire
Harness (98) into the lower end of the Right Upright and
out of the upper end.
Hold the Right Upright (107) against the Base (69).
Be
careful not to pinch the Upright Wire Harness (98).
Insert two Upright Bolts (83), with two 3/8” Star Washers
(87), into the Base, and loosely thread the Upright Bolts
into the lower end of the Right Upright.
With the help of a second person, tip the treadmill onto its
other side. Attach the Left Upright (106) and the other
Wheel (see step 2) as described above. Note: There are
no wires in the Left Upright.
83
69
98
Holes
Brackets
107
106
107
87
3
3a
106
5.
Have a second person hold the console assembly near
the Right Upright (107) as shown. Look under the console
assembly and locate the Console Wire Harness (41).
Connect the Upright Wire Harness (98)
to the Console
Wire Harness (41). Make sure to connect the connec-
tors properly (see the inset drawing). The connectors
should slide together easily and snap into place. If the
connectors do not slide together easily and snap into
place, turn one connector and try again. IF THE CON-
NECTORS ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER IS
TURNED ON.
107
98
41
Console
Assembly
98
41
5
4. With the help of a second person, carefully tip the tread-
mill onto the Base (69), and raise the Frame (38) to a ver-
tical position; do not raise the Frame past the vertical
position. Be careful not to scratch the Frame on the
top of the Uprights, (106, 107).
While the other person holds the Frame (38), orient the
Lift Shock (105) exactly as shown. Attach the Lift Shock
with two Shock Bolts (79) and two Shock Nuts (56). If
necessary, tip the Frame forward or backward slightly to
attach the Lift Shock. Be careful not to scratch the Frame
on the top of the Uprights (106, 107).
Carefully lower the Frame (38) to the floor.
79
56
106
107
69
38
56
79
105
4