Filter
Top Products
3/4Ó Tek Screw (65)Ð6
5/16Ó Star
Washer (77)Ð4
3/8Ó Star
Washer (87)Ð4
Shock Nut
(56)Ð2
Latch Screw (74)Ð2
2Ó Screw (39)Ð2
Wheel Nut
(20)Ð2
Console Bolt (78)Ð4
Shock Bolt (79)Ð2
Wheel Bolt (94)Ð2
Upright Bolt (83)Ð4
6
1. Make sure that the power cord is not plugged in. With
the help of a second person, raise the Frame (38) to the
vertical position; do not raise the Frame past the vertical
position.
While the second person holds the Frame (38), attach the
Right Rear Endcap (58) to the end of the Frame with a 3/4”
Tek Screw (65). Be careful not to overtighten the Tek
Screw. Attach the Right Foot (73) to the bottom of the
Right Rear Endcap with a 2” Screw (39).
Attach the Left Rear Endcap (not shown) and the Left Foot
(not shown) in the same way.
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dis
-
pose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top
of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If
there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive
cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver and
adjustable wrench . For help identifying assembly hardware, see the drawings below.
38
58
65
73
39
1
5/16” Star
Washer (77)–4
Shock Nut
(56)–2
Wheel Nut
(20)–2
3/4” Tek Screw (65)–6
Latch Screw (74)–2
2” Screw (39)–2
Console Bolt (78)–4
Wheel Bolt (94)–2
Upright Bolt (83)–4
Shock Bolt (79)–2
3/8” Star
Washer (87)–4
2. With the help of a second person, carefully tip the tread-
mill onto its left side. Partially fold the Frame (38) so that
the treadmill will be more stable.
Do not fully fold the
treadmill.
Attach the four Base Pads (99) (only two are shown) to
the bottom of the Base (69) with four 3/4” Tek Screws (65).
Attach a Wheel (95) to the Base (69) with a Wheel Bolt (94)
and a Wheel Nut (20). Do not overtighten the Wheel
Bolt; the Wheels must be able to turn freely.
94
69
65
65
99
38
99
2
20
95