Filter
Top Products
HOW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
m
ust connect the AV wire or a CATV cable to the
treadmill (see page 13).
1. Turn on the television.
If there is a sheet of clear plastic on the television
screen, remove the plastic. Insert the key into the
console. See HOW TO TURN ON THE POWER on
page 16. Press the Power button to turn on the
television. Note: If you operate the television with-
out inserting the key into the console, the buttons
on the console will not function.
2. Scan for television channels.
Before operating your television, you must scan for
channels. See page 24 for information on scanning
for channels. Note: To use a VCR or DVD player,
you must connect a VCR or DVD player and then
scan for channels.
Your television can receive analog and digital sig-
nals. For the television to operate properly, good
reception is necessary. Make sure the television
settings are set correctly (see HOW TO ADJUST
THE TELEVISION SETTINGS on page 23). If you
are using an antenna, make sure that it is properly
connected and adjusted for optimal reception (see
HOW TO CONNECT AN ANTENNA on page 13).
3. Select a television source.
Select a television source by pressing the TV/AV
button repeatedly. If you have connected an an-
tenna or a 75 ohm CATV cable to the 75 ohm ter-
minal on the treadmill, select the TV source. If you
have plugged the audio/video wire harness into the
a
udio/video input jack, select the AV source.
T
o use a VCR or DVD player, make sure the VCR
or DVD player is connected correctly (see page
13). Select the AV source and press play on your
VCR or DVD player.
4. Select the desired channel.
When you turn on the television, the screen will
show the last channel that was selected. To select
a different channel, press the numbered channel
buttons on the remote or the Channel increase and
decrease buttons. The selected channel number
will appear on the screen for a few seconds. Note:
Before channels can be selected, they must be
saved in the televisionʼs memory. See page 24.
5. Adjust the volume.
Press the Volume increase or decrease buttons on
the console to change the volume. Note: For best
results, change the volume by pressing the Volume
buttons on the console only. Make sure the audio
wire is not plugged into audio jack on the console.
To use earphones or headphones (not included),
plug them into the headphone jack near the Start
button on the console.
6. Turn off the television.
When you are finished using the television, press
the TV power button to turn off the television.
21