Filter
Top Products
12
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 3/4" Screws (4) from
the Pulse Receiver Cover (70) on the back of the
Console (66).
2. Next, hold the receiver so that the small
cylinder is oriented as shown. Attach the re-
ceiver to the Pulse Receiver Cover (70) with the
two included small screws.
3. Connect the wire on the receiver to the wire ex-
tending from the Console (66). Make sure that
no wires are pinched. Reattach the Pulse
Receiver Cover (70) to the Console with the two
#8 x 3/4" Screws (4). Discard the other wires in-
cluded with the receiver.
If you purchase the optional chest pulse sensor (see page 25), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
66
1
70
4
66
3
70
Wires
Tab
4
70
Cylinder
2
Small Screws
Receiver