Filter
Top Products
9
15. Make sure that all parts are properly tightened
before you use the Light Cycle. Note: Some
hardware may be left over after assembly is
completed. Place a mat under the Light Cycle to
protect the floor or carpet.
13. The Lumbar Cushion (94) requires two ÒDÓ batteries
(not included); alkaline batteries are recommended.
Open the zipper on the back of the Lumbar
Cushion. Press the batteries into the battery clip.
Make sure that the negative (Ð) ends of the bat-
teries are turned away from the motor. Close the
zipper.
14. Slide the Lumbar Cushion (94) over the Backrest
(15) as shown.
94
Zipper
Battery
Clip
Motor
Batteries
15
94
Elastic
Strap
13
14
12. The Console (8) requires either two or three ÒAAÓ
batteries (not included); alkaline batteries are
recommended. Open the battery cover (not shown)
on the back of the Console. Press the batteries into
the battery clip. Make sure that the negative (Ð)
ends of the batteries are touching the springs.
Close the battery cover. Note: If the battery clip
holds three batteries, you must insert three batteries.
12
8
Batteries
Battery
Clip