Filter
Top Products
6
68
1
3
1
1. Loosen the Lock Knob (68) on the right side of the
Frame (1). Slide the Seat Frame (3) out until it
stops. Tighten the Lock Knob.
2. Attach the Upright (2) to the Frame (1) with three
M10 x 25mm Button Head Screws (25) and three
M10 Split Washers (26). Be careful not to pinch
the Reed Switch Wire (13) or the Resistance
Cable (10).
4. Route both Extension Wires (41) up through the
Upright (2) as shown.
Attach the Handlebar (4) and the Light Frame (82) to
the Upright (2) with two M6 x 25mm Hex Head
Screws (14) and two M6 Split Washers (67), but do
not tighten the Screws yet. Make sure that the
Screws are in the indicated holes. Note: Two
more Screws will be attached in step 6.
Remove the backing from the Fastener Strip (77) and
press it onto the Upright (2) in the position shown.
Firmly press the Ballast Box (81) onto the Fastener
Strip.
2
2
26
26
25
25
25
1
10
13
4
3. The light therapy pod requires two GX 24 Q-3 Base
Light Tubes (88). Remove the four #8 x 3/8Ó Screws
(97) from the back of the Left Light Cover (91).
Remove the Left Light Cover. Insert a Light Tube
into the Light Fixture (87). Reattach the Left Light
Cover with the #8 x 3/8Ó screws.
Install a Light Tube (88) into the right side of the light
therapy pod in the same manner.
3
41
2
14
14
82
67
67
77
81
4
97
91
87
88