Filter
Top Products
12
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the Left Side Shield (24) and the Flywheel
Cover (31) must be removed. Using an adjustable
wrench, turn the Left Pedal (20) clockwise and
remove it. Next, remove the indicated Screws (2, 32,
35, 49). Turn the left arm of the Crank (22) to the
position shown and slide off the Left Side Shield and
the Flywheel Cover.
Next, locate the Reed Switch (4). Turn the arms of the
Crank (22) until the Magnet (33) is aligned with the
Reed Switch. Loosen but do not remove the indicated
Screw (35). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console displays
correct feedback. When the Reed Switch is correctly
adjusted, reattach the left side shield, flywheel cover
and left pedal.
HOW TO ADJUST THE DRIVE BELT
The exercise cycle features a Drive Belt (1) that must
be kept properly adjusted. If the Drive Belt slips as you
pedal, it should be adjusted
. To do this, the left side
shield and the flywheel cover must be removed. Refer
to the instructions at the left and remove these parts.
Locate the Drive Belt (1). To tighten the Drive Belt,
loosen the bottom M10 Nylon Locknut (44) and then
tighten the upper M10 Nylon Locknut (44) slightly; be
careful not to overtighten the Drive Belt. When the
Drive Belt is properly adjusted, tighten the lower M10
Nylon Locknut (44). Then, reattach the left side shield,
the flywheel cover, and the left pedal.
1
1
44
44
35
22
4
33
24
20
2
35
49
22
31
32