Filter
Top Products
5
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver , an adjustable
wrench , and a rubber mallet .
Refer to the drawings below to identify the small parts needed for assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 22. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a
part is not found in the parts bag, check to see if it has been pre-assembled.
M10 x 112mm Carriage Bolt (34)–4
M10 x 85mm Button Screw (63)–1
M10 Nylon
Locknut (106)–4
M10.3 Black
Washer (53)–2
M6 Large
Washer (94)–2
M8.5
Washer (45)–2
M10 Split
Washer (70)–1
M8 Large
Washer (113)–2
M4 x 16mm
Screw (66)–4
M8 x 19mm Shoulder
Screw (22)–2
M8 x 19mm Patch
Screw (108)–4
M6 x 16mm Button
Screw (109)–2
M6 x 45mm Flat
Screw (20)–4
M4 x 22mm
Screw (93)–2