Filter
Top Products
8
5. Press three 50mm Square Inner Caps (17) into the
Leg Lever (18).
Attach a Weight Tube (39) to the Leg Lever (18) with
an M8 x 60mm Bolt (43), two M8 Washers (23), the
13mm Spacer (50), and an M8 Nylon Locknut (13).
6
39
18
12
11
6
6
26
19
49
7. Press a 38mm Round Inner Cap (45) into each end
of the Adjustment Tube (29).
To mount the Adjustment Tube (29), insert the end
without the locking clip through the left Upright (1)
from the inside. Then, slide the end with the locking
clip into the right Upright (1). Rotate the locking clip
into place around the Upright. When moving the
Adjustment Tube (29), always make sure the
locking clip is in place around the right Upright
(1).
Tighten all of the Nylon Locknuts used in steps
1 to 7.
5
17
18
17
17
13
50
23
43
39
8. Press 25.4 Square Inner Caps (28) into the ends of
both Backrest Tubes (27).
Attach the Backrest Tubes (27) to the Backrest (15)
with four M6 x 40mm Bolts (4) and four M6 Washers
(30). Do not tighten the four Bolts yet.
6. Press the Angle Cap (49) onto the indicated end of
the Weight Tube (39). Press a 25.4mm Round Inner
Cap (12) into the other end of the Weight Tube.
Lubricate an M10 x 75mm Bolt (26). Attach the Leg
Lever (18) to the bracket on the Front Leg (19) with
the Bolt, two M10 Washers (6), and an M10 Nylon
Locknut (11). Do not overtighten the Nylon
Locknut. You must be able to freely pivot the Leg
Lever.
7
1
1
45
29
45
Locking
Clip
8
15
4
28
4
27
30
30
28