Filter
Top Products
7
3. Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),
and the shipping bracket (C) from the Base (83).
Attach a Wheel (84) with the Bolt and the Nut
that you just removed. Do not overtighten the
Nut; the Wheel must turn freely. Discard the
shipping bracket.
83
4
C
8
3
84
4. Identify the Right Upright (78) and the Right
Upright Spacer (79), which are marked with
stickers. Insert the Upright Wire (38) through the
Right Upright Spacer as shown.
See the inset drawing. Tie the wire tie in the
Right Upright (78) securely around the end of
the Upright Wire (38). With the help of a second
person, hold the Right Upright near the Base
(83). Then, pull the other end of the wire tie until
the Upright Wire is routed completely through
the Right Upright.
83
38
78
79
38
4
Wire
Tie
78
38
2
. Attach two Base Feet (81) to the Base (83) in the
location shown with two Base Foot Spacers (13)
a
nd two #8 x 1" Tek Screws (2). Then, attach the
two other Base Feet (81) with only #8 x 1" Tek
Screws (2).
83
2
2
8
1
2
81
2
81
13
2
81
13