Filter
Top Products
10
10. Insert the indicated connectors and tie into the
Right Upright (78).
Next, set the Handrail Base (96) onto the
H
andrail Spacers (97, 98).
Attach the Handrail Base (96) with four 3/8" x
1/2" Bolts (7) and four 3/8" Star Washers (9);
s
tart all four Bolts and then tighten them.
Press four (three are shown) Handrail Caps (99)
into the ends of the Handrail Base (96).
See steps 5 and 8. Tighten the four 3/8" x 4 1/2"
Bolts (6).
9
9
7
96
78
97
98
9
Tie
C
onnectors
7
99
99
99
1
0
11. Pull the end of the Handrail Wire (52) out of the
hole in the Handrail Base (96).
With the help of a second person, hold the con-
sole assembly near the Handrail Base (96).
Connect the Handrail Wire (52) to the console
wire. See the lower inset drawing in step 8.
The connectors should slide together easily
and snap into place. If they do not, turn one
connector and try again. IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON.
Connect the Console Ground Wire (101) to the
console assembly ground wire. Insert the wires
into the console assembly.
Attach the console assembly with three 3/8" x 3"
Bolts (5) and three 3/8" Star Washers (9). Be
careful not to pinch the wires.
Console
Assembly
96
5
9
11
Console
Wire
52
Console
Assembly
Ground Wire
101