Filter
Top Products
11
Measure your heart rate if desired.
If there are
thin sheets of
plastic on the
metal con-
tacts on the
handgrip
pulse sensor,
peel off the
plastic. Place
your hands on
the handgrip pulse sensor, with your palms on the
contacts closest to you and your fingers touching
the contacts on the opposite side of the handgrip
pulse sensor. Avoid moving your hands. When
your pulse is detected, the heart-shaped indicator
in the upper part of the display will begin to flash
each time your heart beats. After a moment your
heart rate will be shown.
For the most accurate heart rate reading, continue
to hold the handgrips for about 30 seconds.
Note: If you continue to hold the handgrip pulse
sensor, the display will show your heart rate for
up to 30 seconds. The display will then show
your heart rate along with the other modes.
If your heart rate is not shown, make sure that
your hands are positioned as described. Avoid
moving your hands excessively or squeezing the
metal contacts too tightly. For optimal performance,
periodically clean the metal contacts using a soft
cloth;
never use alcohol, abrasives, or chemi-
cals.
Turn on the fan if desired.
To turn on the
fan at low speed,
press the fan but-
ton.
To turn on
the fan at high
speed, press the
fan button a sec-
ond time. To turn
off the fan, press
the fan button a
third time. Note:
If the fan is turned on but the pedals are not
moved for thirty seconds, the fan will automatical-
ly turn off.
Rotate the thumb wheel on the right side of the
fan to adjust the angle of the fan.
When you are finished exercising, the console
will automatically turn off.
If the pedals are not moved for a few seconds, a
series of tones will sound, the time will begin to
flash, and the console will pause.
If the pedals are not moved for a few minutes, the
console will turn off and the display will be reset.
7
65
Fan
Button
Thumb Wheel
Contacts