Filter
Top Products
2. Locate the Left Upright (68), whichhas a name
decal in the indicated location. Press a 25mm
Round Inner Cap (20) into the Upright. Press a 2"
x 3" Inner Cap (25) into the top of the Upright,
Attach the Left Upright (68) to the indicated
Upright Foot (33) with two M16 x 68mm Button
Bolts (64), four M10 Washers (53), and two M10
Nylon Locknuts (56). Do not tighten the
Locknuts yet. Make sure that the Locknute are
on the same side as the M10 Nylon Locknuts
(56) on the Stabilizer (6).
Attach the Left Upright(68) to the Support (7)
with two M10 x 93mm Button Bolts(45), two M10
Washers (53), and two M10 Nylon Locknuts (56).
Do not tighten the Locknuts yet.
Repeat this step with the Right Upright (not
shown).
3. Attach the Inner Crossbar (4) to the Left Upright
(68) with two M1Ox 72mm ButtonScrews (44), a
SupportPlate (71), an M10 x 93mm ButtonBolt
(45), an M10 Washer (53), and three M10 Nylon
Locknuts(56). Do not tighten the Locknuts yet.
4,
Attach the Crossbar (3) to the Right Updght (5)
with two M10 x 72mm ButtonScrews (44), a
Support Plate (71), an M10 x 93mm Button Bolt
(45), an M10 Washer (53), and three M10 Nylon
Locknuts (56). Do not tighten the Locknuts yet.
45<
45
53
71
,_25
Name decal
on this side
44
20
68,
44
44
45
71
6