CONSOLE DIAGRAM
_O_Vl
V'SUi"/'O_
se_,n-_v
A WARN|
r_dmq
_bbob_mt
_mdm_
KJep_ m
POWER INCLINE ONI REEET
©
SPEEDCONTROL
SPEEDTRAININGZONES
Note: If there is a thin sheet of clear
plastic on the console, remove it.
Key
BaRedes
Tab
BATrERY INSTALLATION
The console requires two or three "AA" batteries
(not included). Alkaline batteries are recommended.
Open the battery cover as shown in the drawing at the
upper right. Insertthe batteries into the batterycom-
partment, making sure thatthe negative (-) ends of the
batteries are touching the springsin the battery com-
partment.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
Inset drawing. Make sure that the tab locks Into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord ispropedy plugged in (see page 7).
Stand on the foot railsof the treadmill. Find the clip at-
tached to the key (see the drawing at the top ofthis
page), and slide the clip ontothe waistband of your
clothes. Next, insert the key intothe console. Test the
clip by carefully taking a few steps backward until
the key is pulled from the console. If the key is not
pulled from the console, adjust the position of the
clip as needed.
8