Filter
Top Products
11
10. Remove the plastic ties from the Right Handrail
(90) and the Left Handrail (not shown). If neces-
sary, press the Cage Nuts (38) into place.
H
ave a second person hold the console assem-
bly near the Right Upright (78).
Connect the Upright Wire (77) to the console
w
ire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and
try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS
TURNED ON. Remove the long tie from the
Upright Wire and the tie from the console wire.
Then, insert the connectors into the Right Upright
(78).
Set the console assembly on the Right Upright
(78) and the Left Upright (not shown). Make sure
that no wires are pinched.
78
Console Assembly
Console
Wire
Long
Tie
77
1
0
11. Tighten four M8 x 25mm Bolts (6) with four M8
Star Washers (10) into the Uprights (73, 78) and
the Handrails (89, 90). Start all four Bolts be-
fore tightening any of them.
See steps 4 and 6. Tighten the M10 x 96mm
Bolts (5).
Press the Left Accessory Tray (110) and the
Right Accessory Tray (111) into the Console
Base (88).
6
6
6
10
10
88
110
111
73
89
90
78
10
10
11
77
90
Console
Wire
6
38
Plastic
Ties