Filter
Top Products
11
12. Set the Pulse Support (111) on the console as-
sembly. Make sure that no wires are pinched.
T
ighten two M4 x 20mm Screws (2) into the
Pulse Support (111).
Tighten six M4 x 19mm Screws (35) into the
Pulse Support (111) and console assembly.
Start all six Screws before tightening any of
them.
2
35
35
35
12
111
2
13. Have a second person hold the console assem-
bly near the Right Upright (89).
Connect the Wire Harness (88) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Remove the long tie from the Wire
Harness and the tie from the console wire. Then,
insert the connectors into the Right Upright (89).
Set the console assembly on the Right Upright
(89) and the Left Upright (not shown). Make sure
that no wires are pinched.
89
Console Assembly
Console Wire
Long
Tie
88
13
88
Console
Wire
Console
Assembly