Filter
Top Products
10
9. Press a Base Cap (87) into the Base (95).
With the help of a second person, tip the treadmill
s
o that the Base (95) is flat on the floor.
87
95
9
10. Set the Console (105) face down on a soft sur-
face to avoid scratching the Console. Remove
the ties securing the Pulse Support (111) to the
Console.
Lift off the Pulse Support (111).
10
105
111
11. Identify the Right Handrail (101), which has a
large hole in the location shown. Hold the Right
Handrail near the Console (105). Attach the
Console Ground Wire (112) to the Right
Handrail with a #8 x 1/2" Ground Screw (4).
Next, insert the tie on the console wire into the
large hole in the Right Handrail (101) and out of
the top as shown. Insert the included plastic tie
through the holes in the Right Handrail as
shown. Make sure the plastic tie holds the con-
sole wire to the near side. Tighten the plastic tie.
Attach the Right Handrail with two M4.2 x 19mm
Screws (1). Make sure that no wires are
pinched. Start both Screws before tightening
either of them; do not overtighten the
Screws. Remove the plastic tie.
Attach the Left Handrail (not shown) to the
Console (105) in the same way. Note: There
are no wires on the left side of the Console.
101
Tie
11
1
1
Large
Hole
Console
Wire
Plastic Tie
112
105
4