Filter
Top Products
S3.25 Assembly and Maintenance Guide
page 35
1 2 3 4 5 6
22. Attach Shrouds
Important: Before attaching the Shrouds, make any
necessary adjustments. Refer to Chapter 4,
"Adjustments and Maintenance" on page 36 for
instructions.
A. Place one Large Shroud on each side of the Main
Upright and Rear Upright and attach using
six 2¾-inch bolts
twelve washers
six locknuts
B. Place the Small Shroud around the Weight Stack
and attach it to the Large Shroud using
two ¾-inch bolts
two washers
C. Attach the Small Shroud to the Angle Bracket in
the Main Upright Base using
one ¾-inch bolt
one washer
This completes the assembly of your Precor S3.25.
Step 22. Attach Shrouds
Large Shroud
Small
Shroud
B
2 - ¾" bolts
2 - washers
C
1 - ¾" bolt
1 - washer
Small Shroud
Angle Bracket
Main Upright Base
Weight Stack
A
6 - 2¾" bolts
12 - washers
6 - locknuts
Large Shroud
Main Upright
Large Shroud