Filter
Top Products
S3.25 Assembly and Maintenance Guide
page 15
1 2 3 4 5 6
6. Assemble Leg Curl Seat
A. Attach the Backpad Support Tubes to the Seat
Upright using
one 5½-inch bolt
two ½-inch washers
one ½-inch locknut
Note: The tube with the Selector Pivot Flat is
nearest the Weight Stack. Also, the hole in the
other support tube is positioned closest to the
Backpad Pop Pin, as shown.
Wrench tighten, and then loosen until the support
tube can fall freely without wobbling.
CAUTION: Keep your hands clear to avoid
injury when the support tube falls.
B. Align the Selector Pivot Flat with the Backpad Pop
Pin.
C. Attach the Seat Pad to the Seat Upright using
one 7-inch bolt
one ½-inch locknut
Finger tighten.
D. Center the Precor Belly Band on the Backpad and
attach the lower section of the Backpad to the
lower hole of the right Backpad Support Tube using
one 3¼-inch bolt
one washer
Finger tighten.
E. Attach the Leg Curl Handle to the holes at the top
of the Backpad Support Tubes and to the top of the
Backpad using
two 3¼-inch bolts
two washers
Note: The Handles should point down when
fastened.
F. Wrench tighten all bolts from this step.
If any parts remain, set off to the side for future steps.
Step 6. Assemble Leg Curl Seat
A
C
D
E
2 - 3¼" bolts
2 - washers
1 - 3¼" bolt
1 - washer
Leg Curl
Handle
Backpad
Seat Upright
1 - 7" bolt
1 - ½" locknut
Seat Pad
1 - 5½" bolt
2 - ½" washers
1 - ½" locknut
Backpad Support
Tubes
Seat Upright
Selector
Pivot Flat
Backpad
Pop Pin
B
Belly Band