Filter
Top Products
S3.25 Assembly and Maintenance Guide
page 20
1 2 3 4 5 6
10. Assemble Chest Press Seat
A. Place the Backpad on the floor. Place the Knee
Support (found in Box 1) on the Backpad. Place
the Long Support Tube and Short Support Tube on
the Knee Support. Attach at the top using
one 3-inch bolt
one washer
B. Attach at the bottom using
two 3¼-inch bolts
two washers
C. Attach the seat assembly to the Chest Press
Upright using
one ½-inch x 5¼-inch bolt
two washers
one locknut
Finger tighten.
Note: The Stop Pad on the seat assembly should
be between the Pop Pin and the Support Stop on
the Chest Press Upright.
D. Wrench tighten, still allowing movement.
CAUTION: If you move the Handlebars out of
the way for this step, be careful that they don’t
hit you.
E. Attach the Seat Pad to the Seat Stem using
two 1¼-inch bolts
two washers
Wrench tighten.
F. Slide the Roller Pads onto the Knee Support Rod.
Insert mushroom caps into the ends of
the rod.
Note: If you have purchased the Leg Press Option,
open the S3.25 Leg Press Option box now and begin
with Step 2.
Step 10. Assemble Chest Press Seat
1
2
3
4
Long Support
Tube
Seat Pad
Backpad
1 - ½" x 5¼" bolt
2 - washers
1 - locknut
C
Seat Stem
Short
Support
Tube
2 - 1¼" bolts
2 - washers
E
Knee Support
Long Support Tube
Short Support Tube
2 - 3¼" bolts
2 - washers
B
1 -3" bolt
1 - washer
A
Knee Support
Short Support
Tube
Long
Support
Tube
Backpad
F
Stop Pad
Pop Pin
Chest Press
Upright