Filter
Top Products
S3.25 Assembly and Maintenance Guide
page 19
1 2 3 4 5 6
9. Attach Handlebars
A. Slide each Handlebar (one at a time) on the Pivot
Shaft.
B. To the end of each threaded Pivot Shaft, attach
one ½-inch washer
one ½-inch hat washer
one ½-inch locknut
Note: Tighten the locknut until the Handlebars
don't move. Then,
loosen
the locknut about
one-half turn until the arms pivot freely. A few
threads should show beneath the Pivot Shafts
if you've tightened it properly.
C. Secure the Plastic Caps over the locknuts.
A rubber mallet may be a useful tool to lightly tap
the caps into place.
Step 9. Attach Handlebars
Press Arm
Assembly
1 - plastic cap
Handlebars
Pivot Shaft
1 - ½" washer
1 - ½" hat washer
1 - ½" locknut
A
A
B
C