Filter
Top Products
M9.3x Low-Impact Treadmills Assembly Guide 5
To install the handrail, raise the incline.
CAUTION: Do not stand on the treadmill
while raising the incline.
a. Plug the treadmill into a power outlet.
Locate the I/O power switch on the front
panel and turn the unit ON.
b. Stand beside the treadmill and press
QUICKSTART. If you are prompted for a
password, press
INCLINE ▼,SPEED▼,SPEED▲.
c. When the running belt begins moving,
press the INCLINE ▲ key until the display
shows an incline of 15.
d. When the lift stops moving, press the red
STOP button, and then turn the treadmill
OFF.
Use the ¼-inch hex key to remove the four
handrail clamp screws. Set the lower handrail
clamp and fasteners aside.
Slide the ends of the handrails toward the
center handrail clamp and secure them to
each side bracket using two socket head
screws (C) and two washers (F). Finger
tighten.
Attach the lower portion of the handrails
to the side rails using four socket head
screws (C) and four washers (D). Finger
tighten.
Note: To complete the M9.31 assembly,
skip steps 11 and 12 and continue with
step 13.
On the M9.35 and M9.33, heart rate
cables protrude from the ends of both
handrails. Slide the end of each cable into
its receptacle. Place excess cable inside
the handrail clamp.
Important: The cable receptacles mirror
the connectors so that they cannot be
improperly installed. Do not force a
connection! Take time and look for the
tabs on the connectors.