Filter
Top Products
Assembling the EFX 25
To attach the upright support covers and pivot arm caps:
1. Place one inner and one outer upright support cover
around one of the upright supports, aligning them so that
the arrows on their inside surfaces point toward the front
of the unit.
2. Line up the protrusions on the outer cover with the screw
holes on the inner cover.
3. Apply pressure to both covers so that the protrusions fit
firmly into the screw holes.
4. Secure the upright support covers using two self-tapping
screws.
Figure 18: Upright support cover attachment (right-hand
cover shown)
5. Slide the covers down and snap them into the base
mount.
Note: Be sure to align the covers so that the lip of each
cover fits inside the edge of the base mount and the hook
on the base mount fits into the corresponding slot on the
cover. When you have snapped the covers into place, the
surfaces of the covers and the base mount should line up
smoothly.
6. Repeat steps 1 through 5 to attach the opposite pair of
upright support covers.