Filter
Top Products
page 8
Keys on the Electronic Console
Each key on the electronic console’s keypad provides specific functions. The following information
explains the different uses of the keys from left to right. To locate each key, look at the electronic
console or refer to Diagram 8.
ENTER: Work out specific prompts which appear on the display need to be addressed and then
“entered” into the unit’s memory by pressing the ENTER key.
Ramp Control : Decrease or increase the ramp’s position from 0 to 7. The 0 position provides
the most elongated, elliptical movement. Increasing the ramp position, changes the vertical angle
of the ellipse which causes an upward movement in your stride path and works different muscle
groups in your lower body. As you press the or key, the number that appears in the display
indicates the ramp setting.
PAUSE: To pause during your workout, press the PAUSE key. The displays on the console freeze
and allow you to review your workout statistics. See
Pausing Your Workout
. To resume where you
left off, press PAUSE again.
Hold to Reset: Provides two options depending on the length of time you hold this key down.
• if you hold this key down for 2 to 3 seconds, you can exit a course prematurely and begin a
cool-down period.
• pressing this key (for more than 3 seconds) exits any program that may be active and causes
the scrolling prompt “PRECOR EFX” to appear.
Resistance Control
: The or keys change the resistance by changing the force applied
against your stride which decreases/increases your degree of effort. As you change the resistance,
the display indicates the resistance setting (1 through 10). Because of the EFX’s unique design, two
different options exist to increase your level of effort:
• decreasing the resistance and increasing the strides per minute.
• increasing the resistance and keeping the same strides per minute.
Note: Your work effort can also be affected by the Ramp Control keys.
Scan/Hold: Scanning occurs automatically (every 30 to 45 seconds) in all courses except Manual
mode. In Manual mode, Scan/Hold lets you select the feature that you want to appear on the
display. When the indicator light is next to the feature you want displayed, press Scan/Hold. The
feature remains displayed until you press Scan/Hold again. In other courses, pressing the Scan/
Hold key activates the scan function. Each feature is displayed sequentially and then, the course
profile reappears. Note that Heart Rate only appears if you are using the Precor Heart Rate Option.
Quick Start: Pressing Quick Start at the scrolling “PRECOR EFX” banner or during any of the setup
prompts accesses Manual mode. A default weight of 150 lbs (68 kg) is used to calculate the total
caloric burn. (Refer to
Using the Quick Start Feature
and
Using the Manual Course Program
.)
Customizing the Display
The EFX can display weight in either pounds or kilograms. You can also set the display’s message
scrolling speed. Note that the EFX will retain your selection even when it is turned 0 (OFF) and
unplugged. You can change your selection at any time by repeating the following steps:
1. While the scrolling banner “PRECOR EFX” is being displayed, press the following keys in
sequence: Resistance Control , Resistance Control , and then Quick Start.
2. A prompt (either
U.S. Standard
or
Metric Units
) appears.
3. Any or key lets you alternate between the prompts. Make your selection by pressing
ENTER while one of the prompts is scrolling past.
5. Adjust the message scrolling speed (1 through 32) by pressing any or key. The higher
the number the faster the message scrolls across the display. Press ENTER to select a specific
scrolling speed.
The display returns to the scrolling banner.