Filter
Top Products
page 5
Assembling the 903 Manual Treadmill
Follow the instructions in this section to assemble the 903 Manual Treadmill. It
is important to read through the entire procedure before assembling your
treadmill.
If you do not assemble and use this treadmill according to the
following guidelines, you could void the Precor limited warranty.
Installation Requirements
Follow these installation requirements when installing the treadmill:
• Fill out and mail the limited warranty registration card. The serial
number is written on a label underneath the treadmill on the center
crossbeam. During the assembly process, write the serial number on the
limited warranty card and in this Owner’s Manual (see
Obtaining Service
).
If you want a 903 Service Manual, write to:
ATTN: 903 Service Manual
Precor Customer Service Department
P.O. Box 3004
Bothell, WA 98041-3004
• Set up the 903 treadmill on a solid, flat surface. Do not install the
treadmill on hardwood floors because the wheels might scratch or damage
the surface. If the treadmill is placed on a hardwood floor or a carpeted,
deep-pile surface, place a piece of heavy cardboard, plywood, or other
smooth, flat surface under the unit to protect the floor and treadmill. If the
floor is not flat and even, the running belt may not track properly.
• Locate the treadmill at least 4 feet from walls and furniture. Open space
to the front, sides, and back of the machine make for a safer mount and
dismount and easier belt adjustment.
Assembly Instructions
To assemble the 903 treadmill, review the callouts in Diagram 1 before you take
the following steps:
1. Install the Front Lift Bar assembly. (Diagram 2) With the treadmill base
flat on the floor near the location where you plan to use it, take the
following steps to install the front lift bar:
a. Place the triangular, cardboard end blocks, set aside when you
unpacked the treadmill, under the front of the unit to lift the flywheel
off of the floor.
b. Remove the four bolts and washers from the front lift bar and set
them aside.
c. Slide the front lift bar brackets into the side rail mounts.
Note: You may need to ask for assistance to help you lift the front of
the treadmill to align the front lift bar brackets into the side rail
mounts.