Filter
Top Products
page 4
Unpacking the 903 Manual Treadmill
All Precor products are thoroughly tested and inspected before shipment.
Precor ships the 903 treadmill in three pieces:
• deck assembly
• front lift bar
• hardware kit (contents described below) and literature kit
Diagram 1 shows the treadmill parts after the carton has been removed.
Callouts point to the different parts of the treadmill that are discussed in the
assembly instructions. Unpack the treadmill close to the location where you
plan to use it. Save the triangular end blocks for use in the assembly.
Open the hardware kit and make sure that you have the following items. As you
identify the contents of the kit, check them off below.
2 T-knobs—handrail installation
2 washers—handrail installation
1/4" hex key
If any items are missing, contact your authorized Precor dealer. For the dealer
nearest you, call 1-800-4-PRECOR.
Important: The packaging for this equipment was designed to protect it during
shipment. Please store the original packaging in a safe place in case you need
to ship the 903 treadmill in the future.
Handrail
Front lift bar
Lift bar bracket
Height adjustment pin
Running belt
T-knob
Side rail mount
Flywheel
Diagram 1
Unassembled 903 treadmill.
CAUTION: Place the hex key
in a safe and secure place. If
the running belt should move
off-center, you can use the
1/4" hex key to align it.