Filter
Top Products
page 22
Note: The located in the upper left corner of the
display begins to blink once a heart rate is detected.
2. When the (PULSE) icon is displayed, press the
SELECT button. The icon stops blinking.
3. Press the CLEAR button (“OFF” appears on the display).
4. Press the SET button (“50” appears on the display).
Continue to press the SET button (number increments in
units of 5) until you reach your target heart rate. Your
target heart rate should be the lowest number shown in the
Heart Rate Training Zone. Refer to Diagram 15.
5. To enter the number, press SELECT. An alarm rings every
5 seconds until you reach your target heart rate. If you
drop below your target heart rate, the alarm begins again.
Important: The alarm stops anytime it cannot detect a
heart beat. This can ocur if you remove the ear clip or the
ear clip becomes dislodged. Occasionally, due to
medication, caffiene, or physiology of the heart (such as
an irregular heart beat) the pulse detector cannot correctly
detect a heart beat. Verify the accuracy of the heart rate
reading by taking your pulse one or twice during your
workout.
6. The electronic console retains your target heart rate in
memory (even when the electronic console turns OFF)
until you erase (CLEAR) it. To erase the target heart rate
zone and turn OFF the alarm, press the SELECT button
until the stops blinking. Press the CLEAR button and
press SELECT again.
Resetting Your Workout Statistics
You can clear the displays and reset your workout statistics to
zero by pressing all three buttons (SELECT, CLEAR, and SET)
at the same time. All the features on the display appear and
then TIME displays and the count up continues.