Filter
Top Products
page 10
3. Insert the long screws through the mounting holes on
the clamp. See Diagram 7. You may need to squeeze
the ends of the clamp together to install the screws.
Tighten the screws using a Phillips head screwdriver
until the clamp remains securely in place. A gap
should remain between the opposite sides of the
clamp. See Diagram 7.
Note: If you have difficulty holding the clamp together, you
may want to use a C clamp (see insert on Diagram 7) to
help compress the clamp ends while you tighten the
screws.
4. Unlock and remove the mounting bracket from the
back of the electronic console. (Unlock the mounting
bracket by pushing it down toward the base of the
console.) Refer to Diagram 2 on page 6.
5. Position the mounting bracket onto the handrail clamp so
that the smooth side of the plate is facing you. Refer to
Diagram 7. Secure the mounting bracket by inserting the
two short screws. Tighten the screws into the recessed
holes on the mounting plate using the Phillips head
screwdriver. Do not over tighten the screws because too
much pressure may crack the plastic mounting plate.
6. Unwrap the reed switch wire. The reed switch wire has a
connector on one end and the oblong-shaped reed switch
on the opposite end. Refer to Diagram 5 on page 8.
Diagram 7
C clamp