Filter
Top Products
page 14
5. Remove the paper backing from one side of the thin pad
and press the pad firmly in place onto the flywheel. See
Diagram 11.
6. To mount the magnet and reed switch continue with the
steps below,
Attaching the Magnet and Reed Switch.
Attaching the Magnet and Reed Switch
For the electronic console displays to operate properly, a magnet
and reed switch need to be precisely installed. The magnet is
mounted to the flywheel and the reed switch is placed on the
side rail. Mounting pads indicate where you need to mount the
hardware. Be sure to follow the previous instructions
Installing
the Mounting Pads
before attaching the magnet or reed switch.
To install the magnet and reed switch, take the following
steps:
CAUTION: To ensure the integrity of the reed switch,
lower the handrails before mounting the reed switch.
Allowing excess wire near the flywheel eliminates the
possibility that the reed switch will be pulled out of
position. If you are not sure how to lower the handrails,
refer to your Owner’s Manual.
Diagram 11