Filter
Top Products
946i/932i Commercial Treadmill Assembly Guide 4
Ask your assistant to hold the display console above the
upright supports while you unwrap the cable and feed the it
through the right upright support.
CAUTION: Be aware of the handrail extensions when you
are working around the front of the unit. It is easy to bump
your head or sustain other injuries if you ignore the location
of the handrail extensions.
Pull the cable out through the grommeted hole and connect
the cable to its receptacle on the electronics board. The tab
on the cable connector faces the front of the treadmill. An
audible click is heard when the cable is properly attached.
Important: Make sure the upright bracket and fasteners do
not pinch the cable. Cables damaged by improper installation
will not be covered by the Precor Limited Warranty.
Lower the display console. Avoid pinching the cable by
placing it along the front edge of the upright bracket. Align
the mounting holes and insert six buttonhead screws (B) and
six split washers (C).
Loosely tighten the screws with the
³⁄₁₆-inch hex key to allow room for adjustments.
Important: Do not wrench tighten the screws until the unit
has been fully assembled. Make sure the fasteners do not
pinch the cable. Cables damaged by improper installation
will not be covered by the Precor Limited Warranty.
Upright
bracket