Filter
Top Products
ENGLISH – 15
1.3.3 CADENCE SENSOR
To install the cadence sensor and crank magnet, you need cutters.
1.
max 80 cm /
2’6’’
3.
2 A.
2 B.
1. Check the down tube to fi nd
a suitable place for the
cadence sensor. The sensor
should be attached at a
maximum of 80 cm/ 2’6”
from the mounted cycling
computer. If needed the
sensor can also be attached
to the seat tube.
2. Place the rubber part on to
the cadence sensor (A) and
pass the cable ties through
the cadence sensor and
rubber part holes (B).
3. Clean and dry a suitable
place for the sensor and
adjust the sensor to the
down tube. If the sensor
touches the crank (when
rotating), change the sensor’s
position slightly upwards. Loosely adjust the cable ties. Do
not tighten them fully yet.
4. The crank magnet should be
installed vertically on the
inner side of the crank.
Before attaching the magnet
to the crank, the area should
be cleaned and dried
thoroughly. Attach the magnet to the crank and secure with
the tape.
4.