Filter
Top Products
PBFb01
EXb00 BASE UNIT ASSEMBLY INSTRUCTIONS #!)
Insert one (1) 2 IN. SQ. END CAP into the BASE SEAT SUPPORT and carefully place it on its side
the floor.
o
, ~,8X 1-
Loosely assemble the BASE SEAT SUPPORT to the MAIN BACK SUPPORT, using two (2)
"~
1/4 BOLTS, four (4) 378 WASHERS, two (2) 3/8 LOCK WASHERS, and two (2) 3/8
Insert a 2 IN. SQ. END CAP into the opert end office EASE TEE SECTION.
10.
Loosely assemble the BASE TEE SECTION to the MAIN BACK SUPPORT ASSE~CEBLY (from step
#7), at the following two cormect~on points: END CONNECTION~- one (I) I~ x 5 BC~LT, two (2)
WASHERS, one (I) 1/2 LOCK WASHER, and one (1) 1/2 NUT; and the INSIDE CONNECTION:
(I) I/2 x 7 BOLT, two (2) 1/2 WASHERS, one (I) 1/2 LOCK WASIIER, and one C[) IP-
Carefully stand the MAIN BACK SUPPORT ASSEMBLY (from previous step) in its upright position
and slide it into position to connect with the WEIGHT STACK SUPPORT BASE. Loosely assemble this
connection using, two (2) 1/2 X 3-1/2 BOLTS, four (4) 1.’2 WASHERS, two (2) 1~ LOCK WASHERS,
and two (2) 112 NUTS.
11. Loosely assemble the REAR LEFT UPRIGHT (NOTE: THIS UPRIGHT HAS FIVE (5) HOLES
THROUGH IT) and the REAR RIGHT UPRIGHT to their respective sides at the TOP and BOTTOM
CONNECTION POINTS as follows:
At the TOP CONNECTION POINT, loosely assembling to the TOP BOOIV[ SECTION, use
one (1) 1/2 x 7-1~ BOLT, two (2) 1.2 WASHEIIS, one (1) 1/2 LOCK WASHER, and one (1)
NUT on the outside bolt connection. Use one (1) 3/8 X 7-I/2 BOLT, two (2) 2/8 WASHERS,
(1) 318 LOCI( WASHERS, and one (1) 3/8 NUT on the inside bolt connection. NOTE: ONE
318 DIA. x 2 LG. BUSHING PULLEY must-be assembled between the tu~es on the inside
bolt connection (SEE DETAIL "B").
At the BOTTOM CONNECTION POINT, loosely assembling to the CONNECTOR FLATS
on the WEIGHT STACI~ SUPPORT BASE, use two (2) I/2 x 3 BOLTS, fo,~r (4)
WASI-IERS, two (2) 1/2 LOCK WASI-IERS, and two (2) 112 NUTS. BE CA_I~.EFUL
PLACE REAR RIGHT AND LEFT UPRIGHTS ON THE CORRECT SIDES OF THE ¯
CONNECTOR FLATS on the WEIGHT STACK SUPPORT BASE.
12.
Securely mount the BACK PAD to the MAIN BACK SUPPORT using, two (2) 3/8 x 1-1/4 BOLTS, two
(2) 318 LOCK WASHERS, and two (2) 3/8 WASHERS. BE SURE TO POSITION THE PAD
THAT THE METAL HIDEM WELT CLIP IS POSITIONED IN THE DOWN POSITION.