Filter
Top Products
PBFS01
EXS00 BASE UNIT ASSEMBLY INSTRUCTIONS (STIgP #2)
THE INSTRUCTIONS FOP, STEP #2 ARE TO BE USED WITH DRAWING SHEET #2 & #3 OF 6.
Securely assemble ~wo (2) 3/8 DIA. x 2 IN. BUSHING PULLEYS into the TOP BOO[V/SECTION and
tl~ee (3) 318 DIA. x 2 Ii~. BUSHING PULLEYS ~nto the MAIN BACK SUPPORT, using five (5) 3/8
6-1/2 BOLTS, ten (10) 3/8 WASHERS, and five (5) 3/8 LOCK NUTS.
Attach eight (8) PARAGLIDE STRIPS to the ADJUSTABLE PRE STRETCH SLIDE, as shown
(DETAIL C ON SHEET #2 OF 6), using the following steps:
A.
Thoroughly clean all inside and outside surfaces where the ~araglide strips are 1:o be attached.
B.
Remove the paper backing from the paraglide strips and firmly apply them to all of the shown
surfaces (8 Places).
Loosely assemble one (1) 378 l~IA. x 1 inch BUSHING PULLEY to the ADJUSTABLE PRE
STRETCH SLIDE using one (1) 3/8 x 1-.2/4 BOLT, one (I) CABLE RETA~ANING CLIP, one (1)
LOCI( WASHER and one (1) 3/3 NUT.
4.
Securely tighten all loose bolt connections made to this point, except for any loose pulley connections.
Install two (2) 3/4 DIA. FLANGE BEARINGS into the TOP BOOM SECTION and two (2) 1/2
FLANGE BEARINGS into each side of the neck tube on the BASE SEAT SUPPORT.
Thread the PRESS ARM ADJUSTER into the adjustment nut on the TOP BOOM SECTION. This can be
adjUsted later to give flxe appropriate amount ofPILESS AP, M pre stretch ~ "
Attach eight (8) PARAGLIDE STRIPS to the outside of the ADJUSTABLE ROLLER. PAD SLEEVE
shown in (DETAIL N), using the following steps:
Thoroughly clean all inside and outside surfaces where the paraglide strips are to be attached.
Remove fl~e paper backing from the paragtide strips and firmly apply them to ;tll oft.he shown
surfaces (8 Places)
Assemble the three (.2) SPRING PIN ASSEMBLIES at th~ following places: one (1) re::
ADJUSTABLE PRE STRETCH SLIDE, one (I) for the BASE SEAT SUPPORT, m~d one (I) for
LEG CURL EXTENSION SLIDE, using three (3) PLUNGERS, three (3) I<]qOBS, three (3) SPR.IN~S,
three (3) SPACEILS, and three (3) COTTER PINS, using the following steps:
B.
C.
D.
Assemble the IGqOB to flxe PLUNGER..
Insert the PLUNGER. through the fu’st hole ofth~ housing.
Slip the SPRING, and the SPACER over the end of the PLUN~ER. (IN THAT ORDER)
Insert the PLUNGER. through the second hole of the housing.
Pull back SPACER on the PLUNGER, and insert the COTTER PIN through fl~e hole.
(SEE DETAIL C ON DRAWING)
Insert the ADJUSTABLE ROLLER PAD SLEEVE into the bottom of the LEG CUILL EXTENSION
TUBE until the spring pin engages in hole. (SEE DETAIL N)