Filter
Top Products
FIGURE 13
!IMPORTANT!
SECURELY
TIGHTEN
JAMNUT
;TEP 13:
¯ Screw the threaded end of the CABLE (7) approximately 3/4" into the end of the 20 HOLE SELECTOR SHAFT (5) and tighten
nut securely. See FIGURE 13.
¯ Insert the WEIGHT STACK PIN (10) into the WEIGHT STACK as shown in FIGURE 13.
¯
If the HEAD PLATE (24) does not sit on top of the first WEIGHT PLATE (25), push the head plate down, insert the SELECTOR
(10) and perform several repetitions on the machine. This will relax the cable system and prevent the HEAD PL~E (24) from lifting
¯
If after completing the previous step the HEAD PLATE (24) still does not sit on top of the first WEIGHT PLATE (25) or if there
excess slack in the cable system, adjust the threaded end of the CABLE accordingly and retighten the jam nut.
Thank you for purchasing the Parabody 897104 WEIGHT STACK OPTION. If unsure of proper use of equip-
ment, callyour local Parabody distributor or call the Parabody customer service department at (800) 328-9714.
I
1,2
I
,/2
I
1/2
I
1/2 I 1/2 I
1/2
6
3
I t I I
2
I I I I
0 1
[ I I t
I
1 [ I I I
10