Filter
Top Products
866101 ASSEMBLY INSTRUCTIONS
19.
Insert two 12) I/2 IN. FLANGE BEARINGS into tile BUSHING on the LEG EXTENSION a.,; shown on
drawing.
20. .kssemblc the LEG EXTENSION NECK to the LEG EXTENSION as shown on drawing, using one (I)
? IN. BOLT. two (2) I/2 IN. WASHERS. and one (I) 1/2 IN. LOW HEIGHT LOCK NLIT.
(TI(;HTEN THE CONNECTION ENOUGH TO REMOVE THE PLAY, YET ALLOWING THE
EXTENSION TO ROTATE FREELY)
21.
.,\ssemble four {4/ROLLER PADS to tile LEG EXTENSION as shown on drawing, using two (2)
R()LLER PAD SHAFTS. and Four (4) STAR LOCK COLLARS.
,\m~ch tree (I) 3/4 IN. SO. RUBBER BUMPER to tile LEG EXTENSION approximately wh,~re silown
23. Insert the U-PIN (WHEN NOT IN USE) through the BUSHING of the LEG EXTENSION. and position
t behind lhc WASHER on the WEIGHT PEG of the LEG EXTENSION. (SEE DETAIL C)
>;F.CI IRELY assemble the -~RM CURL PAD to the ARM CURL FRAME as shown on drawing, usin~
m,, ~2~ ~ ,~ X I-I ’4 IN. B(~I.’I’S~ m,o (2) 3/8 IN. LOCK WASHERS, and two (2) 3/8 IN. WASHERS.
Almch two sets oFUPRI(;HT LAI~ELS (I to 12) to the inside surfaces of both UPRIGHT FRAMES
Sllown 011 drawing,;.
6