Filter
Top Products
8661111 ASSEMBLY INSTRUCTIONS
FOR PURCHASING THE 86610.I,STRE,.N.GTH"BUILDING.SYSTEM:-:PLEASE SAVE THESE ASSEMBLY
INSTRUCTIONS FOR YOUR PERSONAL REFEREN.CEi:AND ;ADDITIONAL SERVICE
INFORMATION.’?: : ....
***IMPORTANT***
Tt I E ,~6.6.IO.I.STR.ENGTII B.UILDING SYSTEM MUST BE ASSEMBLED ON A FLAT, LEV!EL
SI~RFACE T() ASSURE ITS PROPER FUNCTION. ./ . :.,. ....
I’AI,IAi~()DY INC. STRONGLY RECOMMENDS THAT THIS PRODUCT BE ASSEMBLED BY TWO
PER,..ONS TO AVOID POSSIBLE INJURY.
IF YOU EXPERIENCE ANY PROBLEM WITH THE ASSEMBLY OF THIS PRODUCT, [’LEASE
CONTACT YOUR DEALER OR YOUR PARABODY CUSTOMER SERVICE REPRESENTATIVE
AT: 1-800-328-9714
TOOLS REQUIRED: RATCHET, 3/4 SOCKET or WRENCH, 9/16 SOCKET or WRL’NCH,
AD.IUSTABLE WRENCH. and RUBBER MALLET or HAMMER
Im, crlo~wll)3X2 IN ISNI)C’/\I
z into the ~.op ofthe UPRIGHT FRAME. and two (2) 2IN.SQ.END
~’.\l’:q into flae BASE oftlac tlPR.IGHT FRAME as shown on dra~ving. Repeat this step for the second
t II’I,I.I(;HT FRAME.
~ECUP, ELy assemble both UI’RIGHT FRAMES to the CROSS BRACE as shown on drawing using
four (41 I/2 X 3-1/4 IN. BOLTS. eight (8) I/2 IN. WASHERS. and tour (4) I/2 IN. LOCI<
(IMP()RTANT: THE ANGLE BRACKETS ON THE CROSS BRACE ARE OFFSET, PLEASE
MAKE SIIP, E TIqAT THE LONGEST END OF THE BRACKET IS FACING UP BEFORE
A.’qS E M BL.Y)
.~E£’UREI.Y assemble the BENCH FRAME to the CROSS BRACE as shown on drawing using two (_.2)
2 X 3-1 4 IN. BOLTS. four/4} I/2 IN. WASHERS. and t~vo (2) I/2 IN. LOCK NUTS.
I~v~crt t~ 12) 1!’2 IN. FLANC.;E BEAI~,INGS into eacl~ end of the BUSHING of the BENCH FRAME as
¯ .;}lOWll 011 kh’L1Wlll~.
¯ ECURELY assemble tl~e BENCH SLIDE to the BUSHING of the BENCH FRAME, as shown on
drawine, using one (I) I.’2 X a IN. BOLT. two (2) 1,’2 IN. WASHERS. and one (I) 1:2 IN. LOCK
"4