Filter
Top Products
835101 HIP SLED ASSEMBLY INSTRUCT’IONS
Insert two (2) 2 IN. SQ. END CAPS into each end of the base of the BASE WELDMENT.
Insert four (4) 1/2 IN. ID FLANGE BEARINGS into the BUSHINGS on the BASE WELDMENT, and
four (4) 1/2 IN. ID FLANGE BEARINGS into the BUSHINGS on the PLATFORM as shown on
drawing.
Assemble the PLATFORM between the BUSHINGS on the BASE as shown on drawing using two (2)
1/2 X 5 IN. BOLTS, and two (2) 1/2 IN. LOCK NUTS. (TIGHTEN THE CONNECTION ENOUGH
TO REMOVE THE PLAY, YET ALLOWING THE PLATFORM ADJUSTMENT TO ROTATE
FREELY)
Attach four (4) PARAGLIDE STRIPS to the end of the PLATFORM ADJUSTMENT, and four (4)
PARA(3LIDE STRIPS to the end of the PLATFORM SLEEVE as shown in (DETAIL B) using
follo~ving steps:
o
Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.
°
Remove the PARAGLIDE STRIPS from the paper ba~king and firmly apply them to all shOWl-i
surfaces.
SECURELY Assemble one (1) SPRING PIN ASSEMBLY to the SPRING PIN BARREL, on the
PLATFORM SLEEVE as shown in (DETAIL A). (!!! IMPORTANT [!! TIGHTEN THE NUT
THE SPRING PIN ASSEMBLY SECURELY)
Assemble the PLATFORM SLEEVE to the BASE WELDMENT as shown on drawing using one (I) 1/2
X 4 IN. BOLT, and one (1) 1/2 IN. LOCK NUT. (TIGHTEN THE CONNECTION ENOUGH
REMOVE THE PLAY, YET ALLOWING THE PLATFORM ADJUSTMENT TO ROTATE
FREELY)
4
10/09/95