Filter
Top Products
FIGURE 15
STEP 15
• Insert two GUIDE RODS (1) into the BASE as shown on FIGURE 15. (NOTE: Lubricate GUIDE RODS (1) with silicon or teflon
spray available at most hardware stores.)
• Slide two 1-1/4 SQ. X 4-7/8” TUBES (3), two 3/4” WASHERS (15), and two WEIGHT STACK CUSHIONS (8) - IN THAT
ORDER - down over the GUIDE RODS (1).
• SECURELY assemble the WEIGHT STACK SHAFT (2) to the HEAD PLATE (4) using one 3/8 X 1-1/4” BOLT (14) and one 3/8”
WASHER (10).
• Using EXTREME CARE slide all fifteen WEIGHT PLATES (16) down over the GUIDE RODS (1) on to the WEIGHT STACK CUSHIONS
(8). Make sure that the keyholes of the WEIGHT PLATES (16) are all facing the right way. (NOTE: If the359101 50 LB. ADD-KIT is
purchased refer to the 359101 ASSEMBLY INSTRUCTIONS now.)
• Insert four CAP PLUGS (9) into the top and bottom ends of the GUIDE RODS (1) as shown in FIGURE 15.
• Slide the head plate assembly down over the GUIDE RODS (1) onto the weight stack.
• Attach the WEIGHT STACK LABELS (18) to the weight stack. Also insert the WEIGHT STACK PIN (7) into the first WEIGHT
PLATE (16) of the weight stack.
9
1
16
BASE
2
10
7
18
8
15
3
14 3/8 X 1-1/4”
4
11
9