ParaBody 441101 440 Home Gym User Manual


 
7
STEP 9
Install the NEW 110-3/4” CABLE ASSY (16) using the following steps:
• Route the CABLE (16) back over one pulley in the TOP BOOM, down through the PULLEY BRACKET (2) and over the second
pulley in the TOP BOOM.
• Route the CABLE (16) around the PULLEY BLOCK as shown in FIGURE 9.
• Route the CABLE (16) through the TOP BOOM as shown in FIGURE 9. The pulleys in TOP BOOM may need to be temporarily
removed to perform this step. (Note: Make sure the CABLE is running OVER the BOLTS connecting the FRONT UPRIGHT
to the TOP BOOM. These may also have to be removed to perform this step.)
FIGURE 9
2
16
FIGURE 10
3/8 X 1-3/4” 13
16
11
2
STEP 10
• Loop CABLE (16) around one 3-1/2” PULLEY (5) in the PULLEY
BRACKET (2) using one 3/8 X 1-3/4” BOLT (13) and one 3/8”
LOCKNUT (11) as shown in FIGURE 10.
5
• Screw the threaded end of CABLE (16) into the HEAD PLATE
ASSEMBLY.
IMPORTANT: Cable must run over the top of
bolts.