Filter
Top Products
28
Axle Peg Assembly Instructions
Non-Threaded
First remove the axle nut from the wheel. There will be either
a retaining washer or a step retaining washer included. Place
this washer between the peg and the frame of the scooter. Slide
the peg onto the axle, followed by a flat washer and lastly the
axle nut. Tighten the axle nut clockwise until the peg fits snugly
against the frame or fork. Repeat for all the remaining pegs.
Non-Threaded
Threaded
Threaded
This style of peg is threaded to fit the axle. Make sure the axle
nut is tight with a 15mm wrench. Place a screw driver through
the mounting holes of the peg and attach the peg to the axle by
turning clockwise. Tighten against the frame or fork for a snug
fit. Repeat for all the remaining pegs.
PLEASE NOTE: Not all axles are able to accept axle pegs.
Please consult the Pacific Cycle Service Department if
you have any questions. Some scooters come with two
or four pegs.
27
Failure to adjust correctly may result in
loss of braking power and personal injury.
Barrel End
Single Cable Casing
Cable Adjuster
Cable Splitter
Upper Cable
(short casing)
Upper Cable
(long casing)
Upper Plate
Bearing
Football Ends
Lower Plate
Lower Cable
Adjusting Barrel
Locknut
Keyed Washer
Locknut
Adjusting Barrel
37mm + or - 1mm
Set for Max. Travel
Minimum 1mm (1/32”)