Oregon Scientific RX109 Watch User Manual


 
GB
26
Cleaning – Clean with a damp cloth. Do not use liquid
cleaning agents, benzene, thinner, or aerosols.
Repair – Do not attempt to repair the product or modify the
circuitry by yourself. Contact the retailer or a qualified
repairman if the product requires servicing. Only use re-
placement parts that are recommended by the manufac-
turer.
Do not scratch hard objects against the LCD display as this
may cause damage.
TROUBLESHOOTING GUIDE
This section includes a list of frequently asked questions for
problems you may encounter with the OUTBREAKER sports
watch. If your watch is not operating as you think it should,
check here before arranging for servicing.
Symptom
Power will not turn
on.
Keys do not respond
Date display is
wrong
Check this
Batteries are
exhausted.
Batteries are inserted
incorrectly.
Key lock in
operation.
(Key icon shown)
Date not set
Problem
No power
Date / time
is wrong
Remedy
Replace with new
batteries.
Insert the batteries
correctly (7).
Press key/lock for 2
seconds (Key icon will
disappear).
Set date correctly (9)
Cannot be changed when
TOUR Mode is operating.
Altitude
reading is
strange
No altitude
alarm
Temperature
reading is
strange
No weather
reading
Wrong unit
reading
(imperial/
metric)
No alarm
Pressure
reading is
strange
Time display is
wrong
Reading is less than
0 (-20, etc.)
Different height
reading at same
point after trip
Alarm does not
sound
Too high
Weather icon
disappears
Incorrect unit setting
Expected alarm
does not sound
Too high or low
Time zone set
incorrectly
Current altitude is
below ground, (watch
sea level
setting)Barometric
changes
Levels not set
Watch is too close to
body
Height displacement
(Vertical movement)
Unit settings
Levels not set
Alarm not activated
Is change due to
wind, pressurized
chamber, or
pressurized
environment
Reset time zone
Cannot be changed when
TOUR Mode is operating.
Reset watch, or accept
reading
Minor pressure changes
may produce minimal
deviations in altitude
readings
Set levels ( 12)
Take off watch, wait 15
minutes, then try again
Remain at fixed altitude
for 5 minutes
Set units ( 9)
Set levels ( see relevant
MODE Section)
Activate alarm ( see
relevant MODE section)
Reset after you have
changed locations
Symptom Check thisProblem Remedy