Filter
Top Products
9
6. Raise the Frame (55) to the position shown.
Have a second person hold the Frame until this
step is completed.
Remove the plastic ties from the ends of the
Latch Assembly (76). Orient the Latch Assembly
so that the large barrel and the knob are in the
positions shown; make sure that all the holes are
aligned as shown in the inset drawings. Attach
the lower end of the Latch Assembly to the
bracket in the center of the Uprights (85) with a
Latch Bolt (109) and a Nut (20).
Attach the upper end of the Latch Assembly (76)
to the bracket on the Frame (55) with a Latch
Bolt (109) and a Nut (20). Note: It may be neces-
sary to move the Frame back and forth to align
the Latch Assembly with the bracket.
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 28).
76
20
20
Large
Barrel
85
109
55
6
109
Knob
Top
Bottom
Holes
Holes
7. Identify the Left Base Cover (88), which has
cutouts in the locations shown. Slide the Left
Base Cover onto the left Upright (85). Then, slide
the Right Base Cover (86) onto the right Upright.
Identify the Left Upright Sleeve (77) and the Right
Upright
Sleeve
(9). Slide the Upright
Sleeves
onto
the Uprights (85) as shown.
88
77
86
9
85
Left
Right
Cutouts
7
5. Identify the Latch Assembly (76). Make sure that
t
he sleeve has been slid over hole 1 and that the
latch knob is locked into hole 1.
Pull on the
sleeve to make sure it is locked into place.
N
ext, make sure that the latch knob is locked
into hole 2. If it is not, pull out the tube until you
see hole 2 and then slide the tube back in until
the latch knob locks into hole 2.
5
Latch Knob
Sleeve
H
ole 1
Hole 2
Tube
76