Filter
Top Products
13
11
2
Hook
Tube
58
ADJUSTING THE DIP ARM
To perform some exercises, the Dip Arm (5) should
be locked in the up position. Remove the Pin (58) and
lift the Dip Handle (11). Engage the Pin into the
Upright (3) and the hole in the Dip Arm plate.
T
o use the Dip Arm (5), remove the Pin (58) and
lower the Dip Handle (11). Insert the Pin into the
Upright (3).
5
3
Hole
6
8
1
19
2
ATTACHING THE SEAT FRAME
The Seat Frame (6) can be adjusted to any of four
heights. To attach the Seat Frame to the resistance
system, set the hooks on the Seat Frame over a set
of tubes on the Upright Base (2).
Store the Seat Frame (6) away from the resistance
system when performing an exercise that does not
require it.
ATTACHING THE LEG LEVER
To use the Leg Lever (8), attach the Pulley Housing
(26) to the Upright Base (2) as described in ATTACH-
ING THE PULLEY HOUSINGS on the previous page.
Attach the Housing Cables (19) to the Leg Lever with
two Cable Clips (49).
T
o use the Curl Bar (28), attach the Pulley Housing
(26) to the Base (1) as described in ATTACHING THE
PULLEY HOUSINGS on the previous page. Attach
the Housing Cables (19) to the Leg Lever with two
Cable Clips (49).
49