Filter
Top Products
11
15. Slide two Small Foam Pads (25) onto the Leg
Lever (8). Press two Endcaps (57) onto the Leg
Lever.
Repeat this step with the Seat Frame (6).
17. Attach the Curl Pad (29) to the Curl Post (9) with
two M6 x 16mm Screws (72).
18. Make sure that all parts have been properly
tightened before the resistance system is
used.
16. Set the Seat Frame (6) on the Upright Base (2).
25
6
8
25
57
57
6
2
29
72
9
15
16
17
14. Grease an M10 x 72mm Bolt (101). Attach the
Leg Lever (8) to the Seat Frame (6) with the Bolt
a
nd an M10 Nylon Locknut (74). D
o not over-
tighten the Locknut; the Leg Lever must be
a
ble to pivot easily.
14
1
01
G
rease
74
6
8