Filter
Top Products
Have a second person hoUdthe consoUe assemMy near
the Upright (111 ), Unsertthe wire harness extending from
the consoUeassemMy through the hoUein the top of the
Upright, Attach the consoUeassemMy to the Upright with
four ConsoUe BoUts(110) and two Star Washers (114),
Firmly tighten the four Console Bolts.
Next, connect the wire harness extending from the con-
sole assembly to the Wire Harness (108), The connec-
tors shouJd slide together easily and snap into place.
If they do not, turn one connector and try again.
Wire
114
Console
Assembly
Note: For clarity, the console assemMy is not shown
in this step.
Orient the Short PaneU(106) so that the indicated notches
are at the top, Have a second person hoUdthe Short PaneU
against the Upright (111), with the top of the Short
Panel flush with the top of the Upright. Route the Wire
Harness (108) down the indicated side of the Short Panel
Next, hoUdthe Long PaneU(112) against the opposite side
of the Upright (111); make sure that the top of the Long
Panel is flush with the top of the Upright and that the
Wire Harness (!08} is not pinched. Press the Long
Panel and the Short Panel (106) together, and align the
three holes in the Long Panel with the holes in the Panel
Brackets (109), Attach the Long Panel and the Short
Panel with three Panel Screws (101),
Firmly tighten the four Upright Botts (113).
3 Notches
112
/
101
101
113