Filter
Top Products
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
in addition to the included tool(s), assembly requires a Phillips screwdriver _C_===_, two adjustable
wrenches __, and a rubber mallet _.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: Some small parts may have
been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.
16mm Wave
M8 Split
Washer (83)-9 Washer (54)-2
M8 Locknut
(1O2)-8
M10 Locknut
(92)-2
19mm Wave
Washer (66)-4
M4 x 16mm
Screw (104)-10
M8 x 80mm Patch
Screw (84)-2
H
M10 Washer
(95)-2
1
M8 x 25mm
Washer (98)-6
M8 x 19mm Patch
Screw (82)-15
M8 x 38mm
Bolt (96)-8
M10 x 45mm Patch
Screw (99)-4
M10 x 60mm
Bolt (100)-2
5