Filter
Top Products
9
Collar
Spring
96
73
Knob
Pin
10.Press the Latch Sleeve (96) into the Left Upright (73). If
necessary, use a rubber mallet to fully insert the Sleeve.
Remove the knob from the pin.
Make sure that the collar
and the spring are on the pin. Next, insert the pin into
the Latch Sleeve (96) and the Left Upright (73), and
tighten the knob back onto the pin.
10
8. Remove the elastic band holding the Upright Wire
Harness (75). Insert the Upright Wire Harness (75)
through a Handrail Spacer (95). Press the Handrail
S
pacer into the top of the Right Upright (74). Press a
Handrail Spacer into the Left Upright (73).
Have two people hold the console assembly near the Left
U
pright (73) and the Right Upright (74). Connect the
U
pright Wire Harness (75) to the console wire.
M
ake sure
to connect the connectors properly (see the inset
drawing); the connectors should slide together easily
and snap into place. If the connectors do not slide to-
gether easily and snap into place, turn one connector and
try again to connect them.
IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
Insert the Upright Wire Harness (75) and the console
wire into the Right Upright (74). Next, insert the brackets
on the console assembly into the Right Upright and the
Left Upright (73). Be careful not to pinch the wires.
74
Console
Assembly
73
C
onsole Wire
75
95
8
75
9. Finger tighten three Handrail Bolts (64), with three
Handrail Star Washers (90), into the Right Upright (74)
and console assembly. Repeat with the Left Upright (73).
After all six Handrail Bolts have been started, tighten
the four front Handrail Bolts first before the other
two Bolts.
9
Console
Assembly
90
64
90
73
74
64